Laser |
The LaserConfig type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | EnableEquallySpacedPulses | Enables or disables generation of equally spaced laser pulses during scanner acceleration or deceleration. |
| EnableGateModulatesLm | Enable/Disable LM signal depending on gate. |
| EnableLaserSync | Enable/Disable synchronization with a free-running laser. |
| EnablePowerCalibration | Enables or disables the use of the power calibration by way of a lookup table. |
| EnablePowerCalibration1 | Enables or disables the use of the power calibration for HotPowerTarget1 by way of a lookup table. |
| EnablePowerCorrection | Enables or disables the use of the position-dependent power correction. |
| EnablePowerCorrection1 | Enables or disables the use of the position-dependent power correction for HotPowerTarget1. |
| EnableTickle | Enable/Disable the output of a tickle signal. |
| EnableVelocityCorrection | Enables or disables the use of the velocity-dependent power correction. |
| EnableVelocityCorrection1 | Enables or disables the use of the velocity-dependent power correction for HotPowerTarget1. |
| FpsPolarity | Polarity of the FPS output signal. |
| FpsStart | Time before marking when fps should be enabled. |
| FpsWidth | Width of the fps signal |
| GateHold | Gets or sets the Gate Hold time. |
| GatePolarity | Polarity of the Gate output signal. |
| GateSetup | Gets or sets the Gate Setup time. |
| HotPowerTarget | Gets or sets the target for the output. |
| HotPowerTarget1 | Gets or sets the target for the second output. |
| LaserTriggerDelay | Gets or sets the laser trigger delay. |
| LMPolarity | Polarity of the LM output signal. |
| PowerChangeSetup | Gets or sets the amount of time the power is updated prior to the next laser event. |
| PowerScale | Gets or sets the current power scale factor. |
| PowerScale1 | Gets or sets the optional power scale factor for the HotPowerTarget1. |
| PowerWriteDelay | Gets or sets the delay between the power update and the assertion of the 'power write' signal. |
| PowerWriteWidth | Gets or sets the amount of time the 'power write' signal is asserted. |
| SimmerPower | Power when laser is on but no marking is done. |
| SimmerPowerTarget | The output target for the simmer power |
| TickleFrequency | Frequency of the tickle. |
| TickleWidth | Width of the tickle. |
See Also