Process |
The ProcessVariables type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | EnableDashedLine | Enables dashed line feature. |
| EnableVariableJumpDelay | Enables or disables the variable jump delay. |
| EnableVariablePolyDelay | Enables or disables the variable polygon delay. |
| EvaluationLeadTime | Gets or sets the condition evaluation lead time for conditional flow-control commands. |
| HeadingScale | Gets or sets the scaling of the heading, or in other words the diagonal part of the heading transformation matrix. |
| JumpDelay | Gets or sets the jump delay. |
| JumpLengthLimit | When EnableVariableJumpDelay is enabled this is the maximum length of a jump vector for which the variable jump delay is being considered. |
| JumpSpeed | Gets or sets the jump speed. |
| LaserOffDelay | Gets or sets the laser off delay. |
| LaserOnDelay | Gets or sets the laser on delay. |
| LmFrequency | Gets or sets the LM frequency. |
| LmWidth | Gets or sets the width of the LM pulses. |
| MagnificationSpeed | Gets or sets the spot magnification speed. |
| MarkDelay | Gets or sets the mark delay. |
| MarkSpeed | Gets or sets the mark speed. |
| MaxDwellTime | If PolyDelay exceeds this value then laser will be disabled during the delay. |
| MinJumpDelay | When EnableVariableJumpDelay is enabled this is the minimum jump delay. |
| OnOffPattern | Gets or sets a pattern for dashed lines. |
| PolyDelay | Gets or sets the poly delay. |
| Power | Gets or sets the output power for HotPowerTarget. |
| Power1 | Gets or sets the output power for HotPowerTarget1. |
| SkyWriting | Configuration of the skyWriting feature |
| SpeedScale | Gets or sets the speed scale. |
| TileOffset | Gets or sets the tile offset. |
| Transformation | Gets or sets the transformation. |
| Wobble | Configuration of the wobble feature |
See Also