3.1.11 X903 PortA |
PortA contains 16 configurable input and output pins.
The direction of the pins can be configured separately for the upper and the lower 8 bits.
The operating and IO-voltage of the whole port can be configured by software to either 3.3V or 5V.
Each port pin contains a 10kOhms pull-up resistor to the port voltage of either 3.3V or 5V.
For more information on Function → Pin Mapping, please see 10.4.1 GPIO Port Function to Pin Mapping
X903 LocationX903 PortA Pinout
|
|
|
X903 PortA Signal Levels
Signal | Description |
|---|---|
TTL IO 3V/5V in 3V mode, as Input | Vih 2V min, max 3.5V Vil 0.8V max, min -0.5V |
TTL IO 3V/5V in 5V mode, as Input | Vih 2V min, max 5.5V Vil 0.8V max, min -0.5V |
TTL IO 3V/5V in 3V mode, as Output | Voh 2.5V min @-20mA, 3.5V max Vol 0.4V max @20mA, -0.5V min |
TTL IO 3V/5V in 5V mode, as Output | Voh 3.7V min @-20mA, 5.5V max Vol 0.4V max @20mA, -0.5V min |
Power 3V/5V in 3V Mode | Voltage: 3.1 .. 3.5V Current: 200mA max. Short circuit protected. Short circuit current 500mA typ. |
Power 3V/5V in 5V Mode | Voltage: 4.5 .. 5.5V Current: 200mA max. Short circuit protected. Short circuit current 500mA typ. |
X903 PortA Mating ConnectorPart | Manufacturer | Part Number | Number Required |
|---|---|---|---|
2.54 mm Female IDC Connector w. Strain Relief WR-BHD 20 pin | Würth | 61202023021 | 2 |
1.27mm Ribbon Flat Cable WR-CAB 1m pieces 20 pin | Würth | 63912015521CAB | 1 |
2.54mm Male SMT Box Header WR-BHD 20 pin | Würth | 61202020621 | 1 fitted on slave board |
See Also