Command |
These are used to mark circular arcs about an absolute center-point.
Overload List| Name | Description | |
|---|---|---|
  | AppendArcAbs(Point2D, Double) | Marks a circular arc from the current position, described by the given absolute center-point co-ordinates and sweep angle. |
| AppendArcAbs(Point3D, Double) | Marks a circular helix from the current position, described by the given absolute center-point co-ordinates and sweep angle. |
| AppendArcAbs(Double, Double, Double) | Marks a circular arc from the current position, described by the given absolute center-point co-ordinates and sweep angle. |
| AppendArcAbs(Double, Double, Double, Double) | Marks a circular helix from the current position, described by the given absolute center-point co-ordinates and sweep angle. |
RemarksThe geometry of circular arcs, as implemented on the SP-ICE-3 Card, is discussed in 9.1.2 Arcs. Note that Transformation is only applied to the center point and not to the individual points on the circle.
See Also