4.3.4 DIP-Switch and Jumper Configuration

The IPG-compatible Adapter hardware can be configured for any one of several similar laser types by means of jumpers W1..W6 and DIP-switch S1.

Note
This page only applies to the current adapter hardware version R2 001 V3 or R3 001 V3.

Jumpers W1..W6

The jumpers are used to select input and output functions of the configurable pins on Connector J1.

J1 Pin Function Mapping

Jumper	J1 Pin	Jumper pins 1,2 (upper pair)	Jumper pins 2,3 (lower pair)
W1	15	Sync_Alarm (Input)	N.C.
W2	11	Alarm3 (Input)	N.C.
W3	24	Back_Alarm (Input)	Reserved_Output_1 (Output)
W4	12	Alarm4 (Input)	N.C.
W5	25	Power_Monitor (Input)	N.C.
W6	13	Reserved_Output_2 (Output)	N.C.

DIP-switch S1

Various combinations of S1.1-4 are used to select:

how to react to the various alarm signals;
whether a custom configuration is loaded from the flash memory;
the specific laser type;
whether the 5V 500mA output on J1 pin 17 is enabled;

Configuration Mapping

Laser	Alarm1 Pin 16	Alarm2 Pin 21	Alarm3 Pin 11	Alarm4 Pin 12	Back_Alarm Pin 24	Sync_Alarm Pin 15	VIO_out 5V Pin 17
IPG Interface B, C, D, E Without external pointer supply. Also valid for: Fujikura FLP-G11 JPT Laser^{[Note 1]} Max Photonics Nufern Laser Raycus SpectraPhysics VGEN Series See: 4.3.4.1 Pre-Configuration IPG Interface B, C, D, E, EG	low normal	high normal	low normal	disconnected	disconnected	disconnected	disabled
IPG Interface B, C, D, E With pointer supply. Also valid for: See above. See: 4.3.4.1 Pre-Configuration IPG Interface B, C, D, E, EG	low normal	high normal	low normal	disconnected	disconnected	disconnected	enabled
IPG Interface EG See: 4.3.4.1 Pre-Configuration IPG Interface B, C, D, E, EG	low normal	high normal	low normal	disconnected	disconnected	disconnected	disabled (do not enable)
IPG Interface G See: 4.3.4.2 Pre-Configuration IPG Interface G	connected	connected	connected	connected	Reserved_Output_1	disconnected	Controlled by PortD.4 (do not enable)
IPG Interface YLP-HP-B See: 4.3.4.3 Pre-Configuration IPG Interface YLP-HP-B	connected	connected	connected	connected	disconnected	disconnected	Controlled by PortD.4
IPG Interface YLP-HP-B See: 4.3.4.3 Pre-Configuration IPG Interface YLP-HP-B	connected	connected	connected	connected	disconnected	disconnected	enabled
Quantel No pointer option See: 4.3.4.5 Pre-Configuration Quantel	low normal	high normal	disconnected	disconnected	low normal	high normal	disabled
Quantel With pointer supply. See: 4.3.4.5 Pre-Configuration Quantel	low normal	high normal	disconnected	disconnected	low normal	high normal	enabled
Flash Mode Use the SPI registers to configure and store a custom configuration to flash memory. In this DIP-switch setting this stored configuration will be loaded automatically. see 4.3.5 Configuration and Status Registers	custom	custom	custom	custom	custom	custom	custom

Notes

Pulse width adjustment is not yet supported.